
5CE / PB
15.06.2009
ReleaseNotes EVS300 SW Release 4.0
5202.6116.00
Page:9 of 13
Functionality:
- Dual Channel support
Second channel can be operated independently and simultaneously from channel 1
- Baseband Input
All measurement modes (except FSCAN) can now operate on the baseband input.
- Graphical FFT Analysis
The demodulated RF or baseband signal is shown in frequency domain
- TCP / IP connectivity
Support for DHCP and gateways
- Hardware Trigger
Recording of values can be triggered by a trigger input signal.
- Distortion measurement for ILS
K2, K3,THD for 90Hz and 150Hz
- Data Logger ILS:
CR91: Graphical analysis of DDM, SDM and level even during measurement.
-
Bugfixes and Improvements:
- Data Logger capacity increased from 50000 elements to 1.000.000 elements
- Course or Clearance configurable as upper frequency
- ILS CRS|CLR shows DDM, SDM and Level of CRS, CLR and CRS+CRS
- FSCAN: Improved user interface and marker handling
- CR150: Setup Analog Out: DDM Range GS CH2 always taken from DDM Range GS CH1
à fixed
- CR146: Datalogger Graph: Cannot place marker on last data element à fixed
- CR145: Datalogger Graph: Cannot enter decimal places for Y-Center à fixed
- CR123: Introduced Status column in datalogger (STIOC) for Startflag, Trigger, Invalid,
Overload, Corrected
- CR122: ILS setting “Single” is factory default (instead of CRS+CLR)
- CR121: DDM values are not shown when SDM < 10% to avoid measurements with non-
ILS-signals
- CR118: Data Logger Graph: X-axis now shows the measurement index instead of
measurement time (easier to handle, faster)
- CR117: HW-revision of modules is displayed
- CR115: ILS CRS|CLR also shows combined DDM, SDM and level
- CR111: Re-work of FSCAN user interface
- CR88: ILS measurement rate reduced from 117 values/s to 100.5 values/s
- CR 79: VOR to/from setting
Comentarios a estos manuales