Rohde & Schwarz VOR/ILS Analyzer EVS200 Manual de usuario descargar pdf (Pagina 6)

5CE / PB

15.06.2009

ReleaseNotes EVS300 SW Release 4.0

5202.6116.00

Page:6 of 13

- The error message “GetILS IO Error” appears in some cases. As long as the measurement

is working, this message can be safely ignored.

- CR216: After Autocalibration the level accuracy at 75MHz is out of limit until the EVS300 is

rebooted

- CR126: “K-MAT” serial number is not displayed in inventory

- CR69: Some remote commands do not check for valid limits

- Battery indication is not as precise as it should be

- Boot time of the new linux is longer than it should be

2.2 EVS300 SW Release 3.3

Release Date: 27.5.2008

RELEASE 3.3 Version

Main EVS Software 1.27m

EVS DSP Software 1.26-5

EVS Keyboard Software 2.20 (ok to use 1.60)

General remarks:

Release 3.3 is a bugfix release and does not offer any new functionality.

Bugfixes and Improvements:

- CR231: ILS, Input BaseBand, View Distortion: K2, K3, THD 90, 150Hz not displayed à fixed

- CR233: FFT analysis on baseband input does not work properly à fixed

- CR232: Remote command “STREAM” does not return any channel indicator à fixed

- CR235: After start in baseband mode, switch to RF input, error “RF3 out of range” is

displayed à fixed

2.3 EVS300 SW Release 3.2

Release Date: 20.3.2008

RELEASE 3.2 Version

Main EVS Software 1.27j

EVS DSP Software 1.26-3

EVS Keyboard Software 2.20 (ok to use 1.60)

General remarks:

Release 3.2 is mainly a bugfix release, but some general improvements are introduced with this

software release as well.

1 2 3 4 5 6 7 8 9 10 11 12 13

Sin comentarios

Rohde & Schwarz VOR/ILS Analyzer EVS200 Manual de usuario Pagina 6